LESSON SUMMARY: This lesson is designed to assist the user in obtaining their frequency information from their Base Station. Frequency information is needed for Receiver/Decoder Module programming and programming for Handheld Irrigation Radios.
Special Tools Needed: None
⚠ CAUTION: THIS LESSON MAY INCLUDE INSTRUCTIONS TO TEST HAZARDOUS VOLTAGES (120V-240V) THAT CAN CAUSE SERIOUS INJURY OR DEATH. IT IS RECOMMENDED THAT A LICENSED ELECTRICIAN BE CONTRACTED TO PERFORM SUCH TESTS.
🛑 STOP: ALWAYS TURN OFF THE POWER TO THE SATELLITE BEFORE REMOVING ELECTRONIC COMPONENTS.
*Before you begin, please make sure that you do not have any irrigation running on your golf course and do not have any scheduled irrigation starts within the next five minutes.
Power OFF the Base Station using the switch on the back left side of the unit
Press and HOLD the number 1 button
Power ON the Base Station while continuing holding the number 1 button
When you see the word “CONFIGURATION” on the display, release the number 1 button
The Base Station should ask for a password…
Press 1, 5, 9, 0
Press the F1 Button
Press 4, 1, 1
The TX frequency should currently be displayed – write it down
Press the PROGRAM button two times
Press 2, 1
The RX frequency should be displayed – write it down (may be the same as TX)
Power off the Base Station using the switch on the back left side of the unit
Wait 10 seconds and then power the Base Station back on
The Base Station should boot back up to the home screen where it should say “PAGER NO =”


Lesson tags: toro, eosmac, toro eosmac, e series osmac, osmac repair, osmac help, osmac troubleshooting, osmac exchange, osmac motherboard, receiver decoder, decoder module, control panel, frequency, osmac rdr, boardtronics
©2022 BoardTronics, Inc. All Rights Reserved. (Read Copyright Statement Here)