ALL U.S. ONLINE ORDERS: FREE 2-DAY UPS® DELIVERY Order by 5 PM ET for SAME DAY SHIPPING (Mon-Fri)

NEW CUSTOMER?
OPEN AN ACCOUNT!

The Brain

An irrigation tech knowledge base, by BoardTronics.

Topics include troubleshooting, how-to's, and more!

HOW TO:

Reinitialize a Timing Mechanism

To reinitialize the Timing Mechanism in your Toro Network LTC® version 1 cabinet, you first need to indentify the sotfware version of your Timing Mechanism. Timing Mechanisms with v1.1 software can run four programs, and Timing Mechanisms with v2.5 software can run eight programs. The reinitialization process is different depending on which version you have.


Reinitializing a v1.1 (4-program) Timing Mechanism

  • Power down the cabinet.
  • Press and hold the down-arrow, up-arrow, and ENTER buttons.
  • Power up the cabinet while keeping these buttons held down for at least five seconds after initiating the power up.

Reinitializing a v2.5 (8-program) Timing Mechanism

  • Power down the cabinet.
  • Press and hold the down-arrow button.
  • Power up the cabinet while keeping this button held down until a second set of rapid beeps are heard.
  • The Timing Mechanism will go through a self-test at this point, checking the memory, flashing all LEDs, activating all display segments, and sequentially activating all stations. The memory is also cleared during this process—only the time and date remain unchanged.
  • After the displays stop sequencing, there will be a single number visible. This is simply a code that changes as different buttons are pressed.

NOTE: reinitializating a Timing Mechanism will erase all program information and replace it with default program settings.

ALL OTHER TORO® NETWORK LTC® V1 TOPICS:

HOW TO: Self-test a Timing Mechanism

To self-test the Timing Mechanism in your Toro Network LTC® version 1 cabinet, you first need to indentify the software version of your Timing Mechanism. Timing Mechanisms with v1.1 software can run four programs, and Timing Mech...

HOW TO: Use Calibration Mode

Calibration Mode is used for testing/troubleshooting/pinpointing issues within the communication system. Follow the steps below to use Calibration Mode on any Network LTC® version 1 satellite: Power down the cabinet...

HOW TO: Use Link Monitor Mode

Link Monitor Mode is used for testing/troubleshooting/pinpointing issues within the communication system. For Network LTC® version 1 satellites, it's only available for Timing Mechanisms with v2.5 (8-program) software...

ISSUE: Intermittent communication problems, or modem is not communicating with central computer

If your Toro Network LTC® version 1 system is experiencing intermittent communication problems, or if your Standard Modem is not communicating with...

ISSUE: Timing Mechanism buttons are not working

If the buttons on the Timing Mechanism in your Toro Network LTC version 1 cabinet are not working, the issue is likely the result of a malfunctioning keypad or malfunctioning buttons...

ISSUE: Timing Mechanism is dead

If the Timing Mechanism in your Toro Network LTC version 1 cabinet is dead or showing no display, follow the steps below to troubleshoot the issue: Check the voltages coming out of the Power Transformer using a...